HRV CONSTRUCTO 1.5ES*(PART NOS 46110 AND 1601702) HRV CONSTRUCTO 2.0ES*(PART NO. 47110)ERV CONSTRUCTO 2.0ES(PART NO. 47115)HRV SOLO 1.5ES*(PART NOS 46
103. INSTALLATION (CONT’D)3.5 INSTALLING THE DUCTWORK AND THE REGISTERS (CONT’D)When performing duct connection to the furnace ducts (Method 1), these
113. INSTALLATION (CONT’D)3.6 CONNECTING THE DUCTS TO THE UNITIf ducts have to go through an unconditioned space (e.g.: attic), always use insulated d
123. INSTALLATION (CONT’D)3.7 INSTALLING THE EXTERIOR HOODSChoose an appropriate location for installing the exterior hoods: • At a minimum distance
134. CONTROLS4.1 INTEGRATED CONTROLAll units are equipped with an integrated control, located in front of the electrical compartment. Use the push but
144. CONTROLS (CONT’D)4.2 ELECTRICAL CONNECTION TO OPTIONAL WALL CONTROLUse the terminal connector included in the installation kit to perform the ele
15NOTE: If an optional auxiliary wall control is activated and then, the Dehumidistat is being activated, the operation of this one will override the
166. WIRING DIAGRAMField wiringremote control(see notes 3 & 4)120 V, 60 HzW1J6J4ELECTRONICASSEMBLY121231234121234512345J8J9J11J1012J12J13J14109876
177.3 BALANCING PROCEDURE1. Set the unit to high speed. Make sure that the furnace/air handler blower is ON if the installation is in any way connec
188. SERVICE PARTSITEM DESCRIPTIONHRV CONSTRUCTO 1.5ESHRV CONSTRUCTO 2.0ESERV CONSTRUCTO 2.0ESHRV SOLO 1.5ESHRV SOLO 2.0ES46110 1601702 47110 47115 46
199. TROUBLESHOOTINGIf the integrated control LED of the unit is flashing, this means the unit sensors detected a problem. See the list below to know
2ABOUT THIS MANUALBecause of the large amount of models covered by this publication, the illustrations are typical ones. Some details of your unit may
209. TROUBLESHOOTING (CONT’D)PROBLEMS POSSIBLE CAUSES YOU SHOULD TRY THIS7. The wall control does not work OR its indicator flashes.• The wires may be
3TABLE OF CONTENTS1. TECHNICAL DATA ...
41. TECHNICAL DATA1.1 AIR DISTRIBUTION (NORMAL OPERATION)1.3 DEFROST CYCLES TABLESHRV CONSTRUCTO 1.5ES AND SOLO 1.5ES UNITSOUTSIDE TEMPERATURE DEFROST
51. TECHNICAL DATA (CONT’D)1.4 DIMENSIONS1.5 SPECIFICATIONSMODEL HRV CONSTRUCTO 1.5ES HRV CONSTRUCTO 2.0ES ERV CONSTRUCTO 2.0ES HRV SOLO 1.5ES HRV S
6(Primarily for homes with radiant hot water or electric baseboard heating.See illustration at right.)Moist, stale air is exhausted from the high humi
73. INSTALLATION3.1 INSPECT THE CONTENT OF THE BOX• Inspect the exterior of the unit for shipping damage. Ensure that there is no damage to the door,
8Use the table below to ensure that the ducts you intend to install will be carrying air flows at or under the recommended values. Avoid installing du
93. INSTALLATION (CONT’D)3.5 INSTALLING THE DUCTWORK AND THE REGISTERSSTALE AIR EXHAUST DUCTWORK:• Install registers in areas where contaminants are p
Kommentare zu diesen Handbüchern